Poison Spyder Crusher Corners Stock for LED Tail and Backup Lights Bare

Get the unique after market corner armor that will provide coverage to the fullest while it conforms to the curves and the contours of the bodyline of the JK. Corner protectors from competitors are brake formed from steel that is flat and so as to install them, large swaths of stock sheet metal might have to be removed. The Crusher Corners from poison Spyder are tool formed so that they match the body lines of the JK and have a close fitting overlay and therefore there is no need for cutting the body except the flush mount LED lights. they usually come in a kit that contain a steel button that is stainless steel. Some drilling will be required so as to install the thread nut-serts.

They were manufactured in that they can work with the high intensity and low profile 4 inch round tail lights that are normally sold separately. The above mention LED lights are known to be brighter but they draw less power than the OE taillights. They are also known to last longer. They have been flush mounted but they barely protrude from the surface of the crusher corner they have been designed like this so that they can survive encounters with item such as rocks and trees that might knock them out of their housing. The crush corners have also been cut so that they can work with two ½ inch round back up lights that are also sold separately. A 5 axis laser was used to make the cut outs so that they fit perfectly.

With the LED tail lights, load resistors will need to be installed so that they can give the correct load resistance and also so that the jeeps computer does not think that th tail lights and the back up lights are out. Poison spyder plug and play offer the easiest installation of the LED tail lights and the back up lights it includes a JK led tail and also a reverse light and also a wiring kit, this is usually sold separately. Crusher Corners are different and they have all been designed in a way that they accept the LED taillights or you can choose to retain the OE tail lights.

It is important that you note that during installation you will have to drill so as to install the 5/16-18 inch nut serts. A rudimentary tool is provided in the kit to enable installation of the nut-serts but using it can be frustrating and tedious.