Without Poison Spyder Rocker Knockers, traveling off the beaten path can be treacherous, especially the further into the wild this path is taken. Places where damage to your Jeep becomes common includes Rocker Panels. These panel protectors are built to guard against environmental attacks from the side and underneath your Jeep, particularly during treks through narrow territory. Rocker Knockers provide a tight fit over Rocker Panels and with very little loss of clearance between the Jeep and the ground.
Machined from a 3/16" high strength steel, using a Laser Cut, and Brake-Formed for that precision, perfect fit. Countersunk bolt holes in the steel plates, allow them to fasten flush against the steel, which enables the Rockers to glide over obstructing objects. Everything needed for proper installation is included: detailed instructions and all the parts necessary for attaching the Rocker Knockers to the Rocker Panels. Because they bolt directly onto the Jeep's body at specific points, there is no risk of misalignment when other components are installed, such as a body lift.
Rocker Knockers also work with other modifications, such as Body Mounts. Off-Roading is fun, exciting, but because the terrain is unpredictable, can be dangerous too. There are times when rocks and other hazards are too high for the Rocker Knockers to keep away from your Jeep. Manufactured using high strength DOM structural tubing and available as an optional add-on, tubular Sliders will protect your Jeep's body. These additional components provide multi-purpose uses. Maneuvering your Jeep around sharp turns just became easier. Sliders will guard against objects that would otherwise have been too difficult to swerve and miss with your vehicle. Also, Sliders make secure steps, for entering and exiting your Jeep. No additional installation is required, the Sliders are welded to the Rocker Knockers using DOM Spacers.