Teraflex Rzeppa High Angle Factory Replacement CV Kit Features:
High Angle CV housing boot and cap
Socket head bolts
CV joint assembly
6 mm Allen wrench and bolt flanges
Low friction CV grease that has high viscosity bonding agents
The Teraflex Rzeppa High Angle Factory Replacement CV Kit is a High-Angle Replacement for your Rzeppa CV Joint
If you have a damage or worn CV joint, a replacement or upgrade can be very expensive. TeraFlex has created the High Angle Rzeppa
Factory Replacement CV Joint Kit to help you retain your driveline, and it's not expensive! The Teraflex Rzeppa High Angle
Factory Replacement CV Kit replaces your worn or damages factory Rzeppa CV joint and driveshaft. This replacement can be done
without resorting to other expensive aftermarket U-joint upgrades. You will benefit from increased CV angles of up to 15 degrees
with this kit. For the complete CV joint replacement kit, you have to go with this high-angle factory replacement CV joint from
Teraflex.
Low-Friction Grease for High RPM Needs
If you happen to have a lifted Jeep Wrangler JK, then the high-angle CV housing of the Teraflex Rzeppa High Angle Factory
Replacement CV Kit will offer an extra benefit with the elimination of the the boot failure associated with 3" or more of lift.
Each CV kit incorporates a low-friction grease into its construction that is engineered specifically for the high RPM needs of
the Wrangler Rzeppa CV joint. This grease has high-viscosity surface bonding characteristics that is absolutely necessary to
properly adhere itself to all the moving surfaces.
Fitment: Jeep Wrangler JK
Important Note: For CV joint longevity, use the proper grease packing as it should be applied thoroughly
and liberally to the full CV assembly. Use all of the grease that's given or you may cause the bearings to fail.