1350 Heavy Duty front driveshaft for 2 and 4 door Jeep JK models with a manual transmission.
This system is a stronger than our 1310 style shaft and takes you from a 26* C.V. angle to a 32* C.V. angle.
Lifts higher than 4.5", long arm lifts & any orher than stock rear axle must be measured for driveline length. See our J.E. Reel "Modifying your Vehicle" page for information on how measure your driveline.
Kit Includes :
2"x.120 Tubing
1350 U-Joints
Cast U-Bolt Style Yoke
1350 U-bolts
Forged T/C Flange
Grade 8 Hardware
Installation Instructions
Requirements:
Dana 44 or Dana 30 Front axle for bolt on application
If you have an application other then the requirements listed above you can still order this kit but you will need to provide us with measurements on how to build your custom driveline. The pricing will remain the sam