The Warn Power Interrupt Kit Allows you to Hook Up Major Power Accessories
Having a plug-in setup for your equipment and accessories can make camping out for the night a whole lot more convenient and
productive. You can more efficiently recharge your batteries and hook up equipment like coolers and lighting. The Warn Power
Interrupt Kit is a great way to hook up your major power accessories to your battery lead, however you can also
disconnect all the power from a dash mounted switch. This would be a great addition if you were to get involved in an emergency situation, and had to shut off the fuel pump, or kill
the power to your engine.
Prevents Battery Drain on Stored Vehicles
With the Warn Power Interrupt Kit, you can use the Power Interrupt if you had to store your vehicle for some time, and did not want
to drain the battery. This is perfect if you have a vehicle that you only bring out to rip up the trails with, and then go back to
your modest ride you use for the public streets. Each kit includes a connection post, switch, and all necessary wiring for a
complete and convenient installation. The connection post allows for easy access that all of your accessories can have room to share.
Fitment: Universal
This is one of those things people overlook when installing their winch. It’s for safety and I I was skeptical about getting this product. I decided to get this because my wireless remote on my winch was activated by accident (not by me). If the other buttons were pushed, my winch could have destroyed my bumper. I have it installed to one of my factory auxiliary buttons. No more worries because there is no power to my winch without pushing my auxiliary botton. It’s super easy to install and should take no more than 45 minutes.
I hooked this up to act as a cut off for the winch. I didn't use the included physical switch and wired the solenoid using one of the terminals on an sPod Bantam. Was able to mount the solenoid on the battery tray barrier of the Jeep JK between the battery and the engine (battery side).
If anything, my only complaint is that the boots for the wires to the solenoid don't really go on easily. Takes a lot of stretching and prying.
Little challenging to find a good location to mount it. Overall its right what I wanted and for the piece of mind that if I am in an accident in the front that it has less of a chance to ground the power wire.
Was this review helpful?
QUESTIONS & ANSWERS
No questions have been asked about this product.
This Part Fits
Universal Product This item is non application specific.
Please verify compatibility before purchase. May require some modification for proper installation.