Steer Smarts Yeti Extreme Bottom Mount Draglink Features:
Easy bolt-on installation
Engineered for proper clearance to other chassis components to eliminate interferences
Ball Joints are fully greasable
Cold headed medium carbon alloy steel ball studs built for heavy use
Large 1 ¼ inch rolled threads at tie rod adjuster and draglink ends provide significantly increased strength
Draglink adjuster is manufactured from large diameter ¼ inch thick wall high strength 4130 Chromoly steel tubing
MADE IN THE USA
The Steer Smarts Yeti Extreme Bottom Mount Draglink is the Strongest Steering Linkage Built for Wrangler JK
STEER SMARTS™ is proud to present our most EXTREME steering linkage “The YETI XD™ Series” linkage for your Jeep JK Wrangler. They
applied their 85 years of steering “lessons learned” to develop the strongest most durable linkage ever built for the Wrangler.
The YETI XD Bottom Mount Draglink is a complete bolt-on draglink. The YETI XD bottom mount installs in just minutes and bolts to
the factory tapered knuckle hole and the factory pitman arm hole. One of the hallmark features of these draglinks is the adjuster
tube that uses adjuster clamps to assure proper clamp force using conventional tools without the possible risk of loosening like
large jam nuts. They are designed with right hand and left hand threads for quick and easy adjustment when installed on the
vehicle. The internal threads and tube are also e-coated for long term serviceability.
Premium Ball Joints and Draglink Ends
The ball joints on the Steer Smarts Yeti Extreme Bottom Mount Draglink are 30mm 1-1/2 ton and are designed specifically for the
Jeep Wrangler JK. Each Induction heat treated ball studs provide ultimate fatigue strength and superior off-road durability.
Steel on steel bearings provide exceptional ball joint wear resistance and robustness. The High quality seals ensure long ball
joint life. Steer Smart's superior seals have been rigorously tested to minimize leakage between grease service intervals which
greatly improves their ball joint reliability over our competition. The draglink ends featured and their external threads are
even e-coated for durability and long term serviceability. They are forged from medium carbon high harden-ability steel and heat
treated for greater buckling, impact, and fatigue strength. Each draglink end uses a Unique “Reverse Pin” technology prevents our
linkage from flopping or rocking. This technology is built into the socket unlike the weak external supports on some competitor
linkages.
Fitment: Jeep Wrangler JK
Important Note:
A minimum of 17” wheels is recommended. 16" wheels with a maximum 4.5 back spacing might fit but not guaranteed.
Draglink fits all left hand drive JK Wrangler models 2007 to 2017 including Rubicon and Unlimited.