Synergy Manufacturing Track Bar Bracket Front Features:
For Lift Kits 3in And Taller
Strong Construction
Corrects Roll Center Geometry
Bolt-on Installation
Limited Lifetime Warranty
Decreases Body Roll That Comes With lifts
If you want to throw on a track bar or a lift to your Jeep, make sure it is on there securely with this bracket from Synergy Manufacturing. Track bar brackets are ideal for those of you who are planning on lifting your vehicle. Or perhaps you may have purchased a vehicle with a pre-existing lift. When you lift your vehicle, you are increasing body roll, and roll-center geometry because the taller the chassis, the more body roll will be increased during cornering. The Synergy MFG Front Tack Bar Brackets will correct your roll center geometry once you lift your vehicle, and these kits are compatible for lift kits 3” or taller.
Strong Construction With Bolt-On Installation
The Synergy Front Track Bar Relocation Brackets are rafted from 3/16” steel, and they feature a 2 stage powder coated finish for maximum strength and durability. These are a bolt-on design that will strengthen the factory mount that is prone to failure. With that said with basic hand tools, you can install this kit yourself with some patience.
Used this bracket when adding the Synergy drag link and tie rod. Flipped the drag link and now the bumpsteer is gone. Should have done this years ago. Jeep has a Metal Cloak 3.5" lift and steers like a new Jeep now.
My Jeep feels a lot better after installing the part. My Jeep felt loose before installing the part, but now the drive quality is a lot better. The only issue I have is that the U bolt hits my steering stabilizer and makes a small rattling noise.
Got a 4.5in lift that included frame aide drop, was experience bump steer and decided to give a axle side bracket a try. Fixed my bump steer and tightened up my steering with the corrected geometry