This is a great solution for those that are looking to move their license plate from the normal lower corner where the plate can easily be damaged while on a trail to another location. It also great for those that want a spare tire and still want to move their license plate. The license plate can be relocated to the center of the spare tire and can be mounted off the existing spare tire using mount studs. The license plate can work with the stock and other aftermarket spare tire mounts. It will eliminate the factory license plates that are plastic or steel which usually protrude from the driver's side at the back. They usually work great with stubby rear bumpers and corner guards and replacement fenders to offer high clearance with a clean look. They have been formed from 10 gauge steel. They have a glossy powder coat that is black and is durable. The plate mount is adjustable from 4-1/4 inches to 6-1/4 inches and can be adjusted so that they offer clearance for almost any size of wheel. The mount can be easily disconnected to allow quicker access to the spare wheel when one needs it. The mount has been mounted on the spare wheel using studs and push nuts so that they stay in when removing or installing the spare wheel. To maintain the legal lighting on the license plate a high quality water proof polycarbonate license plate with two high power LEDs are included. There are elaborate instructions on the wiring of the lights. In the kit there is a cover for the license from the factory.